General Discussion > Help Desk

spindle sander problems

(1/4) > >>

hayshaker:
I have a spindle sander the one that goes up&down, yeah anyhow
how does one keep the sandingtube from continually slipping off
i stopped using for some time because of that. and i would like to start using it again,
help needed

madmax:
I have been pondering this for awhile and all I can think of is dirty comments.

wsdstan:
Oh, you watched one going up and down didn't you?

wsdstan:
Mike if the paper tubes are coming off you may have a problem with the rubber tube or you bought some sleeves that are not the correct size by just a little bit.  Clean the tubes of all debris and see how tight the fit is when you slide the sanding tube on.

What brand is yours?

madmax:

--- Quote from: wsdstan on August 06, 2018, 11:50:40 AM ---Oh, you watched one going up and down didn't you?

--- End quote ---

I take offense at your accusation of my autoeroticism?. especially with sandpaper.

Navigation

[0] Message Index

[#] Next page

Go to full version